How to start the trackless electric flat car correctly
2020-11-14Start correctly, let the trackless electric flat car start smoothly without impulse, vibration, and flameout. The key to a smooth start is to correctly grasp the coordination between the contact point of the trackless electric flat car clutch and the accelerator pedal. When you start, if you feel insufficient motivation, you should step on it immediately.
When the trackless electric flat car starts, it must overcome the inertia and greater resistance of the flat car. Generally start with low gear. The driver should pay attention to the up and down situation around the vehicle before getting on the vehicle, and ensure the correct posture when starting. The sequence of operations is:
1. Start the engine according to the order and method of starting the electric flatbed truck engine, and observe whether the instrument is working normally and whether the water temperature is normal.
2. Depress the clutch pedal and place the shift lever in the low gear position (first gear, second gear or third gear).
3. Hold the steering wheel of the excavator transporter with your left hand, hold the parking brake lever with your right hand and press the button.
4. First quickly raise the clutch pedal to the contact point, and lightly depress the accelerator pedal. When you feel a slight change in the engine sound, gradually add fuel, then slowly raise the clutch pedal while relaxing the parking brake lever to make the electric flatbed start smoothly. The clutch pedal, accelerate appropriately, and start again.
Matters needing attention when the trackless electric flat car starts:
1. It is forbidden to put your feet on the clutch pedal after starting to avoid accelerating the wear of the clutch.
2. In order to prevent gear crashing when starting and shifting gears, you should stop for 1-3 seconds after stepping on the clutch pedal of the electric flatbed truck (when the rotation speed of the first shaft of the transmission slows down or stops rotating), then engage the required gear Bit.
3. When starting, if the gear cannot be engaged at one time, you can release the clutch assist plate once and then engage it, or try to engage other gears first, and then suspend the starting gear.