What is the protection method of battery china apparatus trolley cart charging?

The use of battery china apparatus trolley cart does not know how to use the battery.

 

The charging method

 

Equalizing charge way: first, will have a normal rechargeable battery and end of charging, let stand for 1 hour, then use of the second stage of the normal charging current continue to charge, until the onset of severe air bubbles, at 1 hour.This is repeated several times until the voltage and density remain the same, and then after the intermittent recharging, the gas bubble will burst.

 

In the equilibrium charging, the voltage, density and temperature of each battery are measured and recorded.Before the end of charging, the density and level of the electrolyte should be adjusted to meet the requirements.

 

Charge and use precautions.

 

1. The battery cover is forbidden to place any conductive material to prevent the formation of battery short circuit.

 

2. After discharging, the battery should be recharged in time, and the maximum time interval should not exceed 24 hours.

 

3. In the application of battery, if there is a backward battery, it should be found out in time and repaired immediately. If it cannot be repaired, the new battery should be replaced.

 

4 injection water storage battery and the sulfuric acid solution, the temperature should be between 10 ~ 35 ℃, shoulds not be too high or too low.

 

5. The charging chamber is strictly prohibited from fireworks, preventing the explosion of hydrogen explosion.Charging outstanding ventilation equipment into the indoor environment, and the room temperature is not less than 15 ℃.

 

6. The surface, connecting line and bolt of the battery shall be kept clean and dry.If you have acid, apply the cotton yarn to the solution, then rinse it with water and dry it.In the process of finishing, the alkali solution must not be allowed into the battery.

 

7. The connection of the battery must be kept in good touch to prevent the spark from causing the pole to burn or the battery to burst.

 

8. Battery should prevent overcharge, overdischarge, strong charging and insufficient charging, otherwise the battery life will be shortened.

 

9. The battery is prohibited from falling into any harmful substances.Measurement of electrolyte density, temperature and liquid surface equipment and equipment should be kept clean to prevent impurities in the battery.In the application of the battery, the voltage, density and capacity imbalance will often occur.In order for the battery to achieve a balanced and uniform state of use, the battery should be charged once a month.