Because of its structure and its main function, most of the china material handling trolleys are made of smaller polyurethane wheels or nylon wheels, which will cause the chassis to be very low.That is to say, when the level ground is placed, the chassis of the china material handling trolley is less than the distance from the ground.Most of the stacker ride height less than 10 cm, generally speaking, there are supporting leg stacker ride height is generally in 3-5 cm, combined with the rear wheel base before is typically more than 1 meter, so the structure of chassis caused the stacker gradability is necessarily very limited;Another plus for stacker is driven by electric or human movement, so the slope is too large, when the china material handling trolleygo will cause the motor power is not enough to drive the vehicle and human can't promote slope lift the china material handling trolley.Therefore, the demand for the slope is higher with the use of the china material handling trolley and the china material handling trolley.
 

The average height of a stacked china material handling trolley is 5 to 7 degrees.That is to say when full load is 5 °, empty running time is 7 °.Of course, this is the official parameter information for most of the china material handling trolleys.Sometimes can be a little more than this Angle, but exceed the scope of also only stay in 1-2 ° Angle, but also need to calculate according to the model.

 

Simply put: to make sure that the electric china material handling trolley can go downhill, the slope should be 10 times greater than the vertical.The longer the slope, the smaller the slope, the easier it is to pass.