Driving mode and operational considerations of trackless transfer cart

Trackless transfer cart generally has two driving modes: industrial transfer cart is powered by on-board battery and driven by motor. Battery-powered transfer cart is a typical zero-emission vehicle.No fuel, no exhaust gas from combustion, no coolant, oil and other pollutants.Nowadays, with the increasingly serious air pollution and the exhaust emission problem of traditional fuel vehicles can not be solved thoroughly, transfer cart has attracted more and more attention.Trackless transfer cart or transport equipment driven by cable traction motor.It is used for the transportation of rock (ore) stone and material.There are: self-propelled mine trucks; scrapers suitable for short and medium distance transportation; or long distance transportation.Trackless transfer cart is powered by automotive diesel engine, which provides power for the vehicle. The vehicle has large power and low cost, and can work 24 hours a day.But the shortcoming is that the noise and vibration are big and polluted.The main driving modes of cable-coiled trackless electric flat car are electric drive, which consists of cable coil, permanent magnet coupler, cable-releasing hysteresis, sliding ring collector, clutch drive sprocket, chain and mounting bracket.Transportation equipment driven by cable traction motor completes forward and backward.Compared with the three power supply modes, battery power supply has advantages of low noise and vibration, energy saving and environmental protection.


Trackless transfer cart has been widely used in the production and transportation of factories in recent years. In other words, the daily production and transportation of factories can not be separated from transfer cart, so ensuring the safe operation of transfer cart is to ensure the safe and normal production of factories.It matters a lot, so the safe operation of transfer trolley can not be ignored.Transfer trolley must be operated and maintained by a dedicated person. Non-operators are not allowed to use it freely.Before the trackless transfer cart operator works, it is necessary to check whether there are obstacles on the track, whether the electrical circuit and control switch are safe and reliable.battery powered transfer cart can start smoothly only after ringing the bell, and pay attention to the abnormal situation around, ready to stop at any time.Industrial battery powered transfer cart shall not collide with the rail end stop.battery powered transfer cart should move slowly and not change its direction quickly.Material transfer cart is not allowed to be repaired and cleaned during operation.When loading objects, overloading is not allowed, and the objects are stacked evenly.After overhaul, material transfer cart must be checked and accepted by the user, and only after meeting the safety requirements can it be used.In case of sudden power failure in material transfer cart operation, the control switch should be restored to zero position. After work, the power supply must be cut off.Unload the load and clean the equipment.