What Are The Requirements For Turntable Transfer Cart
2019-04-12What are the requirements for Turntable Transfer Cart
1.Equipment structure:The turntable transfer cart is composed of a frame,a rotating table,a driving device and a control box.The rail flat turntable body is equipped with a guide rail for 90o rotation.It has the characteristics of flexible rotation,quick response and reliable performance.The track docking is realized by the frequency converter to realize the automatic deceleration control,and an electronically controlled limit device is arranged between the two positions of 90o, so that the positioning of the rotating table is accurate when the rotating table is rotated,so that the body rail and the ground track are well aligned;The auxiliary support wheel set ensures the stability of the rotating table.
2.Frame system:The frame structure of the frame is composed of a longitudinal beam,a beam and a steel plate to form a "#" character skeleton frame structure,and a steel plate is laid on the work surface.The profiles and steel plates used comply with the corresponding national standards.
3.Transmission system:The motor drives the reducer to transmit the power to the rotary device and drive the rotary table to rotate.Each component is reliably coupled to the body.The motor uses a brake motor with a degree of protection of IP44 and an insulation class of E.
4.Control system:There is a control box on the ground.There are left-hand,right-hand,jog and stop buttons on the control box, and corresponding indicators are provided.
2.Frame system:The frame structure of the frame is composed of a longitudinal beam,a beam and a steel plate to form a "#" character skeleton frame structure,and a steel plate is laid on the work surface.The profiles and steel plates used comply with the corresponding national standards.
3.Transmission system:The motor drives the reducer to transmit the power to the rotary device and drive the rotary table to rotate.Each component is reliably coupled to the body.The motor uses a brake motor with a degree of protection of IP44 and an insulation class of E.
4.Control system:There is a control box on the ground.There are left-hand,right-hand,jog and stop buttons on the control box, and corresponding indicators are provided.
5.Derusting coating requires the surface descaling of steel plates,profiles and castings to reach ST2 level in GB8923.The film thickness is 90-120um.All exposed work surfaces are rust-proof before leaving the factory.The surface is coated with anti-rust primer,dark gray finish,and the guide rail is not painted.
6.Control box system:The control box is made of steel plate,beautiful and practical,the surface is treated with anti-corrosion treatment.The thickness of the box is not less than 2 mm.There is a good heat dissipation device.There is a practical inspection lamp inside the control box.The door lock is firm and reliable. Easy to use,no interference.
6.Control box system:The control box is made of steel plate,beautiful and practical,the surface is treated with anti-corrosion treatment.The thickness of the box is not less than 2 mm.There is a good heat dissipation device.There is a practical inspection lamp inside the control box.The door lock is firm and reliable. Easy to use,no interference.
7.Equipment configuration:Industrial components should be selected to provide sufficient guarantee for the overall reliability of the equipment.
